05-22-2018, 02:49 AM
How can we control the bubbles produced in insulating glass glue Solve the method of controlling the bubble generation of hydrogen-containing silicone oil: Strictly shut off the raw materials, and cannot use discounted slate outside dining set raw materials that can be condensed and dehydrogenated with the sealed glass-rubber base material, especially raw materials that are doped with hydrogen-containing silicon oil and other hydrogen-containing substances to avoid bubbles The production. Sealing glass glue due to the ambient temperature, high humidity or excessive addition of B component caused by the excessive curing reaction, resulting in the release of small glass encapsulation by-products can not be released in time to form bubbles.
The solution to this problem is to: a. Control the ambient commercial interior wall panel systems suppliers temperature and humidity of the production of insulating glass glue, and avoid construction under high temperature and rain. b, in strict accordance with the proportion provided by the sealed glass adhesive product specification to measure the ratio; c, from time to time to check the design diagram (such as glue pump, adjusting mechanism, mixing glue, glue gun, etc.), so as to ensure the mixing ratio Cut Composite Fencing column Correct.
When it is found that the plastic machine leaks and it causes bubbles in the glass glue, a slight air leakage can be achieved by tightening the screw on the rubber pump. If the leak is particularly severe, you must replace the new beat pump or replace the worn seal. . Bubbles caused by non-standard construction: Generally, this situation is related to excessive glue injection. Therefore, the air bubbles thoughts on area pvc floor covering in this case must be filled with moderate pressure.
The solution to this problem is to: a. Control the ambient commercial interior wall panel systems suppliers temperature and humidity of the production of insulating glass glue, and avoid construction under high temperature and rain. b, in strict accordance with the proportion provided by the sealed glass adhesive product specification to measure the ratio; c, from time to time to check the design diagram (such as glue pump, adjusting mechanism, mixing glue, glue gun, etc.), so as to ensure the mixing ratio Cut Composite Fencing column Correct.
When it is found that the plastic machine leaks and it causes bubbles in the glass glue, a slight air leakage can be achieved by tightening the screw on the rubber pump. If the leak is particularly severe, you must replace the new beat pump or replace the worn seal. . Bubbles caused by non-standard construction: Generally, this situation is related to excessive glue injection. Therefore, the air bubbles thoughts on area pvc floor covering in this case must be filled with moderate pressure.