07-03-2018, 02:02 AM
When purchasing eco-boards, we not only need to understand the dimensions of eco-boards, but also understand the quality of eco-boards. First, put an eco-board in a dimly lit place, and if the ecological best roof application wood terrace or balcony trinidad and tobago surface is flat at a 45-degree angle, then the three surface stitches and sanding marks will not be obvious. If this is obvious, then the eco-board The quality is not good.
Observe whether the decorative paper on the surface of the ecological board is firmly attached to the wood. If it is not attached firmly, the sawing meeting will appear in the side of the construction, which will not only increase the outdoor tech fence iran difficulty of processing but also directly affect the appearance. In addition, we can use strong glue to pull hard on the corner of the eco-board to see if it will pull up the paper, or hand-swiping on the cross-section of the eco-board to see if it will pull out the paper.
If the surface of the eco-board has a shiny, punctiform or blocky appearance, if the surface is used for a long time, the surface will be black or 4x4 end caps for decking new zealand the phenomenon of falling paint will occur. This kind of plate should not be purchased. If there is a layer of fog on the surface of the eco-board, it should not be purchased. The inspection method is to wipe the surface of the eco-board with lipstick, and it can be completely wiped off in a few minutes. Under normal circumstances, before the eco-board is made into a finished product, if there is a slight deformation of wood plastics composite planter the top two sheets of paper, it is a normal phenomenon. However, if the finished product is deformed, it will be a quality problem.
Observe whether the decorative paper on the surface of the ecological board is firmly attached to the wood. If it is not attached firmly, the sawing meeting will appear in the side of the construction, which will not only increase the outdoor tech fence iran difficulty of processing but also directly affect the appearance. In addition, we can use strong glue to pull hard on the corner of the eco-board to see if it will pull up the paper, or hand-swiping on the cross-section of the eco-board to see if it will pull out the paper.
If the surface of the eco-board has a shiny, punctiform or blocky appearance, if the surface is used for a long time, the surface will be black or 4x4 end caps for decking new zealand the phenomenon of falling paint will occur. This kind of plate should not be purchased. If there is a layer of fog on the surface of the eco-board, it should not be purchased. The inspection method is to wipe the surface of the eco-board with lipstick, and it can be completely wiped off in a few minutes. Under normal circumstances, before the eco-board is made into a finished product, if there is a slight deformation of wood plastics composite planter the top two sheets of paper, it is a normal phenomenon. However, if the finished product is deformed, it will be a quality problem.