table to install the back plate,
#1
technology caused by skewed parts. Wooden furniture to have the safety and stability, when the two doors open 90 degrees, the hand gently pull forward, the cabinet can not automatically tilt forward; bookcase door glass to be treated; Dressing table to install the back plate, the pressure should be fixed glass surface. Individual parts of furniture (such as legs, drawers, doors or stents, etc.) must be sufficient. You should light the furniture on the corner or sitting
on the side, try furniture is solid. 6, observe the board strength board can be used to emphasize the finger press to feel the fastness of the board. One side of the material should be well-shaped skeleton to be fixed, if the skeleton sparse, one by one will feel the virtual surface is not real, the panel quiver great; drawer floor, hand pressure, to test the strength of the general multi-layer with the board, large area The partition plate should be made of five layers.
Door and drawer switch to be flexible. When the panel is covered with veneer and other materials, the color of the product should be similar to that of the complete product. The surface of the product is not allowed to wrinkle, sticky and leaky. 7, check the drawer of the slide and the latch drawer should be solid and solid, tighten the screw inside. May wish to pull the drawer, the activities of the desktop, doors and other parts, to ensure that can be used freely,
balcony recycle plastic railing designs pictures
outdoor cabin deck railing
discount composite deck railing cost
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Plate.n.Sheet.v4.12.12.e dvdget3 0 344 10-27-2020, 08:12 AM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 418 10-14-2020, 07:06 AM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 378 10-12-2020, 04:27 PM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 392 10-12-2020, 02:34 PM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 380 10-10-2020, 09:16 AM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 430 10-09-2020, 10:27 PM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 385 10-08-2020, 09:13 PM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 347 10-07-2020, 05:19 AM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 407 10-04-2020, 11:05 PM
Last Post: dvdget3
  Plate.n.Sheet.v4.12.12.e dvdget3 0 381 09-27-2020, 11:00 AM
Last Post: dvdget3

Forum Jump:


Users browsing this thread: 1 Guest(s)