Wooden floor laying process
#1
1, in order to prevent the accumulation of detergent in the groove, soak the detergent rags try to wring dry. Floor wax remover can cause marks and bulges on the floor, never use it. Wipe with wiping cloth. Wipe with a hard cloth wringer. Floor surface, especially the groove part, to carefully wipe, do not leave detergent. Such as residual detergent and moisture, can cause the surface whiten, bulging.
2, everything should pay attention to fully dried: If not fully dried, the floor wax will not be closely attached to the floor surface, affecting the appearance of white phenomenon.
3, at least three times to fight the wax, each time with a non-fuzz cloth or waxer to rub the floor so that oil penetrate the wood.
4, in order to get the glittering consequences, every time you hit the wax with a soft cloth light rub polish.Each fight again, to be dry, with very fine sandpaper polished appearance, clean, hit the second time.
"wpc decking materials china supply,cheap anti corrosive composite deck boards,wher to buy recycled plastic fencing"
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Oil And Gas Process Software'20 dvdget3 0 398 10-28-2020, 10:31 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 452 10-27-2020, 01:41 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 424 10-14-2020, 01:05 AM
Last Post: dvdget3
  tecnomatix v14.02 Process Simulate Designer dvdget3 0 413 10-13-2020, 11:28 PM
Last Post: dvdget3
  TWI RiskWISE 5 for Process Plant v5.1.0.28350 dvdget3 0 401 10-12-2020, 02:05 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 391 10-12-2020, 02:39 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 342 10-11-2020, 02:19 PM
Last Post: dvdget3
  tecnomatix v14.02 Process Simulate Designer dvdget3 0 380 10-11-2020, 12:33 PM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 370 10-10-2020, 06:04 AM
Last Post: dvdget3
  Oil And Gas Process Software'20 dvdget3 0 323 10-08-2020, 10:13 PM
Last Post: dvdget3

Forum Jump:


Users browsing this thread: 1 Guest(s)